How to manage fail2ban

From http://www.rentpbx.com/support/knowledgebase/23/I-Cannot-access-my-PBX-Server-it-is-down.html

1. find out your public ip by going to www.whatismyip.com from your local pc browser
2. you can add your public IP to / etc/ fail2ban/ jail.conf file, next to ignoreip
Hint: you can use vi by typing below (no spaces after / space after vi )

vi / etc/ fail2ban/ jail.conf

see http://www.washington.edu/computing/unix/vi.html for more info on using vi

3. Put in your public IP next to ignoreip and make sure to comment out the mark/# (delete # sign)
Hint: Type i to start modify the file in vi. You can put in as many public IPs as you want, separate by space.

ignoreip = 127.0.0.1 xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy

4. save and exit out. see http://www.washington.edu/computing/unix/vi.html for more info on using vi
Hint: You hit Esc key then type :wq

5. do again vi / etc/ fail2ban/ jail.conf to make sure the changes you made is there and correct
Hint: To exit without saving, you hit Esc key then :q

6. restart fail2ban service by typing

service fail2ban restart
service iptables restart

7. Do NOT close your ssh, open another ssh session to test you can now access it
8. if test successful, you are done, if not, check the steps again

Hasznosnak találta ezt a választ?

 Kinyomtatja ezt a cikket

Olvassa el is

How to activate Affiliates program

Activate your affiliate account today to: Receive an initial bonus deposit in your affiliate...

High CPU usage due to whois process

We have seen some of the PBX experience high CPU usage due to spinning whois process. If you...

Firewall Configuration

All of our installation, except for the PBX in a Flash, comes with apf firewall pre-installed....

How to change Hostname in the server

To change the hostname in the server, just ssh to the server as root and type...

Change Timezone

When we provisioned our PBX,  we will provision it to USA Pacific Daylight Timezone....