Firewall Configuration

All of our installation, except for the PBX in a Flash, comes with apf firewall pre-installed.  The number of port open may or may not be sufficient for your requirement.  You are free to change them.  You may also replace it with other firewall.  You may do so since you will be granted a root access.

Please note that it is your responsibility to keep your server secure.

Here are some information about apf http://www.rfxn.com/projects/advanced-policy-firewall/

For  PBX in a Flash, please refer to "Firewall Configuration" in the PBX in a Flash specific FAQ.

UPDATE:

As of 1/10/2011 any new server and rebuild server will have combination centos iptables firewall and fail2ban

Hjälpte svaret dig?

 Skriv ut denna artikeln

Läs även

I Cannot access my PBX Server, it is down

This is for when you cannot even ssh to your PBX IP or you keep getting disconnected. If you're...

Issue with IAX Call rejected, CallToken

If you have problem connecting through IAX protocol, please check if you see " Call...

Change Timezone

When we provisioned our PBX,  we will provision it to USA Pacific Daylight Timezone....

Call Quality Troubleshooting

In the case that you are experiencing bad call quality please consider the following suggestions....

XEN ERROR: 4GB SEG FIXUP

If you update or install new packages,  please make sure that you check /var/log/message....