XEN ERROR: 4GB SEG FIXUP

If you update or install new packages,  please make sure that you check /var/log/message.  Some of the package may revert/overwrite xen patches on libc6.  The result you will see large amount of 4GB SEG FIXUP in your message log.  Although it seems harmless at first, this problem will impact the performance of your server considerably.  

Should your server experience this issue, please do the following procedure in your server through ssh

mv /usr/lib/tls /usr/lib/tls.disabled

echo "hwcap 0 nosegneg" > /etc/ld.so.conf.d/libc6-xen.conf

ldconfig

reboot

 

If the problem persist, please contact support. 

 

 

 

Bu cevap yeterince yardımcı oldu mu?

 Bu dökümanı yazdır

Also Read

Call Quality Troubleshooting

In the case that you are experiencing bad call quality please consider the following suggestions....

I Cannot access my PBX Server, it is down

This is for when you cannot even ssh to your PBX IP or you keep getting disconnected. If you're...

How to reboot your pbx server

If you have problems getting into your pbx, first please read this to make sure it is not banned...

Firewall Configuration

All of our installation, except for the PBX in a Flash, comes with apf firewall pre-installed....

High CPU usage due to whois process

We have seen some of the PBX experience high CPU usage due to spinning whois process. If you...